Close
Wireless Setup Using Standard Setup
Before Starting Wireless Connection Setup
Caution
Make sure that the printer is turned on.
1. Press the HOME button (A) on the printer.
2. Flick the screen left or right, then tap the [WLAN].
Tap [Wireless LAN setup].
3.
When the screen left above is displayed, go to the step 4.
When the screen right above is displayed, go to the step 5.
4. Tap [ To other connection methods ] on the printer.
5. Tap [ Standard setup ].
6. Tap your access point.
Caution
If a different screen appears, see "If an Error Screen Appears" below in this page and follow the instructions there.
7. Either of the following screens should be displayed:
If [ Connected to the access point. ] appears on the printer, the network does not require a password.
Caution
If a different screen appears, see "If an Error Screen Appears" below in this page and follow the instructions there.
8. Tap the screen.
9. Enter the network password (WEP key or passphrase).
Character entry is case-sensitive so be sure to confirm.
Caution
- Character Entry
You can enter the characters when the keyboard is displayed on the printer. Follow the procedure below.
(1) You can enter the characters when the keyboard is displayed on the printer screen.
Character entry is case-sensitive.
(2) Tap the character you want to enter.
(3) Repeat 1 and 2 to enter the remaining characters.
- To insert characters, move the cursor to the character on the right of the target position using the
10. Tap [ OK ].
11. Make sure that the network password is correct.
Character entry is case-sensitive.
12. Tap [ OK ].
Caution
If a different screen appears, see "If an Error Screen Appears" below in this page and follow the instructions there.
13. When the left screen appears, tap [ OK ].
Caution
If a different screen appears, see "If an Error Screen Appears" below in this page and follow the instructions there.
The wireless LAN setup in the standard method is completed.
Install the software.
If an Error Screen Appears
Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back on.
The message appears when multiple access points with the same name are found.
- When you have only one access point.
Select [ Use one AccessPoint only ], then tap [ OK ].
Select the MAC address of the target access point on the displayed screen.
For details on how to check the MAC address of the access point, refer to the access point manual or contact its manufacturer.
- When using multiple access points
Tap [ Use multiple AccessPoints ].
Access points in use nearby may also be detected.
Access point names with double-byte characters are not displayed properly. However, they can be selected.
Refer to the access point manual or contact its manufacturer.
Refer to the access point manual or contact its manufacturer.
Make sure that the passphrase entered for the access point is correct.
Make sure that the WEP key entered for the access point is correct. In addition, when using WEP key number 2, 3 or 4 of the access point, set to use WEP key number 1, or select a WEP key number by entering wireless connection settings of the printer directly.