Solution
Confirming the Size IndicationPreparing the [Ink Cassette]
Preparing the [Paper Cassette]
Installing the [Ink Cassette] and the [Paper Cassette]
Setting Up and Connecting the Printer
Caution
Confirming the Size Indication
1. Confirm that the [Paper cassette] and the [Ink cassette] have the same size indication.
[Paper cassette]
[Ink cassette]
Preparing the [Ink Cassette]
2. Confirm that the [Ink sheet] is taut with no slack.
shows the normal condition. shows that the [Ink sheet] is slack.
3. If the [Ink sheet] is slack, take up the slack with the following procedures.
Push the spot indicated by inward, rotate it in the clockwise direction to roll up the [Ink sheet]. Roll up the [Ink sheet] until the slack is taken up. Rolling it up too much may reduce the number of prints that can be made.
Caution
Do not pull or touch the [Ink sheet] with bare hands. Also, do not hold the [Ink Cassette] with wet hands. This may cause the printing errors.
Preparing the [Paper Cassette]
4. Open the lid.
There are two layers of lids. Open the ⋖outer lid⋗ first, then open the ⋖inner lid⋗ .
5. Hold the paper as shown in the illustration and load with the glossy side up. Do not touch the print side (glossy side) of the paper with your fingers. This may prevent you from making clean prints.
Caution
6. Close the lid.
Close the ⋖inner lid⋗ until it clicks into place. Leave the ⋖outer lid⋗ open during printing.
Caution
Installing the [Ink Cassette] and the [Paper Cassette]
7. Open the ⋖Paper cassette compartment cover⋗ and the ⋖Ink cassette compartment cover⋗ of the printer.
⋖Paper cassette compartment cover⋗
⋖Ink cassette compartment cover⋗
8. Insert the [Ink cassette].
Insert the [ink cassette] into the printer in the direction indicated by the arrow on the cassette until it clicks and locks into place.
Close the ⋖ink cassette compartment cover⋗.
9. Make sure that the outer lid is open and insert the [paper cassette] all the way into the compartment.
Setting Up and Connecting the Printer
10. Set up and connect your SELPHY printer in the following manner for safe use.
Make sure there is at least 10 cm (4 in.) of free space around printer.
Make sure there is free space of at least the length of the paper behind printer. (During printing the paper will pass in and out.)
Connect the [Compact power adapter] to the printer.
Insert the [Power cord] to the [Compact power adapter].
Plug the other end into a [Power outlet].
Caution
- Close to a motor or other devices that generate strong magnetic fields
- Near a television or radio set
Caution
You can use the battery pack [NB-CP2L] (sold separately) and charger adapter [CG-CP200] (sold separately) to print images where there is no power outlet.